"6422", "at24", "at3d".
The AT25 is Chipset "at3d" and the 6420 is 6422.
The driver will auto-detect the amount of video memory present for all
chips. The actual amount of video memory can also be specified with a
VideoRam
entry in the config file
N'34'DeviceN'34'
section.
The following driver
Options
are supported:
- Option N'34'HWCursorN'34' N'34'booleanN'34'
-
Enable or disable the hardware cursor. Default: on.
- Option N'34'NoAccelN'34' N'34'booleanN'34'
-
Disable or enable acceleration. Default: acceleration is enabled.
- Option N'34'NoLinearN'34' N'34'booleanN'34'
-
Disable or enable use of linear frame buffer. Default: on.
Note: it may or may not work. Tell me if you need it.
- Option N'34'PciRetryN'34' N'34'booleanN'34'
-
Enable or disable PCI retries. Default: off.
- Option N'34'Remap_DPMS_OnN'34' N'34'stringN'34'
-
- Option N'34'Remap_DPMS_StandbyN'34' N'34'stringN'34'
-
- Option N'34'Remap_DPMS_SuspendN'34' N'34'stringN'34'
-
- Option N'34'Remap_DPMS_OffN'34' N'34'stringN'34'
-
Remaps the corresponding DPMS events. I've found that my
Hercules 128/3D swaps Off and Suspend events. You can correct
that with
- Option N'34'Remap_DPMS_SuspendN'34' N'34'OffN'34'
Option N'34'Remap_DPMS_OffN'34' N'34'SuspendN'34'
in the
Device
section of the config file.
- Option N'34'SWCursorN'34' N'34'booleanN'34'
-
Force the software cursor. Default: off.
- Option N'34'ShadowFBN'34' N'34'booleanN'34'
-
Enable or disable use of the shadow framebuffer layer. Default: off.